| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Removal of inner speedo cable https://www.slantsix.org/forum/viewtopic.php?t=57679 |
Page 1 of 1 |
| Author: | crickhollow [ Tue May 12, 2015 11:24 pm ] |
| Post subject: | Removal of inner speedo cable |
How do I remove the inner speedo cable? I have a 62 Valiant/Signet and have the cable disconnected at both cluster and traany. I have not been able to pull the inner cable from the cluster end or the tranny end. |
|
| Author: | Louise76 [ Wed May 13, 2015 9:56 pm ] |
| Post subject: | |
If it was working, then I think it should come out the top. If it wasn't working, my guess is it is fubar- as in unravelled inside the outer housing. |
|
| Author: | crickhollow [ Sun May 17, 2015 3:51 am ] |
| Post subject: | |
I got it out from the top after using some heavy elbow grease. I think the inner cable was held in by lubricant that had dried hard over the years of non-use. I have cleaned the inner cable and it looks ok to use again. Any idea on how I could clean the inside of the outer speedo cable of the congealed grease/lubricant? Thanks |
|
| Author: | NEVjr [ Sun May 24, 2015 10:02 pm ] |
| Post subject: | |
Quote: I got it out from the top after using some heavy elbow grease.
i would try flushing it with a varsol bath, but make sure varsol wont harm it first
I think the inner cable was held in by lubricant that had dried hard over the years of non-use. I have cleaned the inner cable and it looks ok to use again. Any idea on how I could clean the inside of the outer speedo cable of the congealed grease/lubricant? Thanks |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|