| Slant Six Forum https://www.slantsix.org/forum/ |
|
| What does it typically cost for a dyno run? https://www.slantsix.org/forum/viewtopic.php?t=5787 |
Page 1 of 1 |
| Author: | DusterIdiot [ Sun May 18, 2003 10:50 pm ] |
| Post subject: | What does it typically cost for a dyno run? |
I'm just curious if anyone knows what it typically costs for a day on a chassis or engine dyno? I have been given a 'contact' in my area that is a small shop off the beaten path that I hear is a great place for the price. I might do this later to see what's best for my build up, or do it with the long rod build I'm planning....  thanks, -D.Idiot |
|
| Author: | cycledog [ Mon May 19, 2003 1:04 pm ] |
| Post subject: | |
A place here in town charges $75.00 don't know if thats good or bad. |
|
| Author: | DusterIdiot [ Mon May 19, 2003 5:50 pm ] |
| Post subject: | err.... |
Is that per hour, per 'pull'per $75???? The place I'm looking at, is $500 per 8 hour day on the chassis dyno, no matter how many pulls you run on the rollers... -D.Idiot |
|
| Author: | 87Slant_sickness [ Tue May 20, 2003 3:19 pm ] |
| Post subject: | |
D.I Around here it usually costs 20bux for a "run" on the dyno, i should be getting my G-Tech in the mail anytime now, but i'm curious to see how "accurate" it is. Not sure how much it would be to rent the dyno for the day, but i bet 500bux isnt far off  Justin |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|