| Slant Six Forum https://www.slantsix.org/forum/ |
|
| looking for a 8 1/4 suregrip rear https://www.slantsix.org/forum/viewtopic.php?t=58914 |
Page 1 of 1 |
| Author: | bigcasey123 [ Sun Jan 03, 2016 5:43 pm ] |
| Post subject: | looking for a 8 1/4 suregrip rear |
i need to upgrade from a 7 1/4 2.76 rear end.i am looking at a 8 1/4. i need something that will hold a 318 while i rebuild my slant 6. from what i heard an 8 1/4 will hold a small block v8. if anybody know where i could buy a decent suregrip rear ready to go i would appreciate the info. thanks |
|
| Author: | Reed [ Sun Jan 03, 2016 7:21 pm ] |
| Post subject: | |
Where are you located? I have a non-sure-grip A body 8 1/4 rear axle I would sell cheap. |
|
| Author: | bigcasey123 [ Sun Jan 03, 2016 8:24 pm ] |
| Post subject: | |
i live in lancaster PA. about an hour and a half from philly |
|
| Author: | Reed [ Sun Jan 03, 2016 9:05 pm ] |
| Post subject: | |
Ah. Never mimd. I live in Tacoma, WA, about 30 minutes south of Seattle. |
|
| Author: | bigcasey123 [ Mon Jan 04, 2016 8:00 am ] |
| Post subject: | |
thats only like a 36 hour drive lol |
|
| Author: | dookdart [ Thu Jan 28, 2016 7:31 pm ] |
| Post subject: | |
bigcasey; a 7.25 will hold up against a mild 318 if you don't flog it. Many 273 cars had the 7.25. The later M body (5th aves) used 7.25s too. People look under them and see 3" tubes and say " ah hah! 8.25" but if you look close, the tubes swage down at the center section to 7.25 size. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|