| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 1970 Dart A-833 Shifter Location https://www.slantsix.org/forum/viewtopic.php?t=59631 |
Page 1 of 1 |
| Author: | casedawg [ Wed May 11, 2016 1:28 pm ] |
| Post subject: | 1970 Dart A-833 Shifter Location |
Does anyone have the measurement for where the shifter is located in the car in relation to the firewall or bellhousing face? How far away is it? Thanks, Casey |
|
| Author: | Nicademas [ Wed May 11, 2016 5:30 pm ] |
| Post subject: | |
Its kinda pricey but this might help you. http://www.classicindustries.com/produc ... m1227.html |
|
| Author: | casedawg [ Thu May 12, 2016 2:23 pm ] |
| Post subject: | |
I'm looking for the info for a transmission swap other than a stock 4 speed. I'm guessing that piece just nests into the contours of the floor for location rather than placing it a certain distance from the firewall. Any 4 speed A body owners out there who could take a quick measurement? |
|
| Author: | 62 alum [ Mon May 30, 2016 11:15 am ] |
| Post subject: | |
I measured 19 inches from the bell housing/transmission interface to the center locating bolt for the hurst shifter. This is on a a833 od a/f trans. Hope this is of some help. |
|
| Author: | casedawg [ Tue May 31, 2016 5:35 pm ] |
| Post subject: | |
Thanks! So that is basically to the base of the shift lever where it comes through the floor? |
|
| Author: | 62 alum [ Wed Jun 01, 2016 3:06 pm ] |
| Post subject: | |
Yes, When the transmission is in neutral the shift lever is in the vertical position coming thru the floor. The bolt I spoke of is directly below the lever. Also measured a stock 3 speed with floor shift, same thing 19 " |
|
| Author: | casedawg [ Wed Jun 01, 2016 5:49 pm ] |
| Post subject: | |
Thanks. That helps me confirm what I need for my 6 speed conversion. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|