| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Crush thickness oil pan seals https://www.slantsix.org/forum/viewtopic.php?t=60348 |
Page 1 of 1 |
| Author: | ceej [ Sat Oct 22, 2016 4:44 pm ] |
| Post subject: | Crush thickness oil pan seals |
We're building a new pan for the digger. The rubber seal that goes between the rear seal retainer and the pan; how thick is that seal when the pan is torqued to spec? CJ |
|
| Author: | sandy in BC [ Sat Oct 22, 2016 4:53 pm ] |
| Post subject: | |
.75 cm .20 " 65 pan on 75 block....felpro gasket |
|
| Author: | ceej [ Sat Oct 22, 2016 5:04 pm ] |
| Post subject: | |
Thanks Sandy! CJ |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|