| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Corteco Head Gaskets... https://www.slantsix.org/forum/viewtopic.php?t=61362 |
Page 1 of 1 |
| Author: | DusterIdiot [ Thu Jul 13, 2017 4:19 pm ] |
| Post subject: | Corteco Head Gaskets... |
I've never used one, but have one sitting on the shelf from someplace I got it long ago... What's the highest static compression ratio anyone's used these at? I have to pull the head off the hpak duster since it's not oiling the rockers or shaft... the engine is 12.18:1 so I would normally go with the Victor Reinz/Mahle gasket since I know they hold up to the pounding...but I have this Corteco gasket on the shelf.... Anyone? Inquiring minds want to know! |
|
| Author: | Exner Geek [ Thu Jul 13, 2017 5:11 pm ] |
| Post subject: | |
I had good luck with them, I presume you mean the white ones, but my compression was in the low 11s. They are a bit thicker I think .055 so they reduce compression a bit. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|