I pull the engine
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| remove tranny and bell housing together or separate https://www.slantsix.org/forum/viewtopic.php?t=61427 |
Page 1 of 1 |
| Author: | DadTruck [ Mon Jul 24, 2017 9:50 am ] |
| Post subject: | remove tranny and bell housing together or separate |
need to pull the tranny and bell housing to get to the throw out bearing on the a833 / 83' D150 from the folks that have done this is it easiest to pull the tranny and bell housing as one unit or is it more manageable to pull the tranny and then go back and get the bell? and, same question on the re install,, put em back as two separates or as one unit? I am doing this task with the truck up on jack stands, thanks |
|
| Author: | Joshie225 [ Mon Jul 24, 2017 1:09 pm ] |
| Post subject: | |
I always pulled my A833s before the bell housing. The trans is plenty big and heavy all by itself. |
|
| Author: | Rick Covalt [ Mon Jul 24, 2017 1:16 pm ] |
| Post subject: | |
I pull the engine
|
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|