| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Magnecor wire size help requested! https://www.slantsix.org/forum/viewtopic.php?t=61668 |
Page 1 of 1 |
| Author: | halfafish [ Mon Dec 04, 2017 12:44 pm ] |
| Post subject: | Magnecor wire size help requested! |
Upon receiving several recommendations, I am ordering a set of Magnecor wires for my car. It is going to be a moderate build, estimated to be in the 160-170HP/230TQ range when done. I have the following parts on the shelf ready for installation: Stock, recently rebuilt bottom end (.040 over) with a freshening up and honing of the cylinders Two-row timing chain Street-duty pocket ported head, 1.68/1.44 valves, shaved to get a DCR of about 8.1 Dutra Duals with SSD's exhaust system recommendation Offy 4-bbl intake Edelbrock AVS 500 carb Moderate cam reground by Oregon Cam Super Six dizzy recurved by DI (thanks!) with HEI upgrade My question is, what size Magnecor wires would work best with this setup? They offer three sizes, in 7mm, 8mm, and KV85 8.5MM. I have no experience with wire size, I've always run whatever came from the local parts store. Does anyone have experience or advice to offer? |
|
| Author: | SlantSixDan [ Mon Dec 04, 2017 3:21 pm ] |
| Post subject: | Re: Magnecor wire size help requested! |
Get the 8mm. |
|
| Author: | wjajr [ Thu Dec 07, 2017 11:17 am ] |
| Post subject: | Re: Magnecor wire size help requested! |
I installed 8mm Magnacore wires on my 67 about seven years ago, still like new, no electron leakage. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|