Stock 225 pushrod. I have a set of Smith Bros. that I think I had built for Bill. Tag says the length is 9.750". I know these are shorter, but I can't remember how much.
Thanks!
Found it on Rockauto. 9.9540"
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Pushrod length? https://www.slantsix.org/forum/viewtopic.php?t=62364 |
Page 1 of 1 |
| Author: | slantzilla [ Sat May 19, 2018 9:14 pm ] |
| Post subject: | Pushrod length? |
Stock 225 pushrod. I have a set of Smith Bros. that I think I had built for Bill. Tag says the length is 9.750". I know these are shorter, but I can't remember how much. Thanks! Found it on Rockauto. 9.9540"
|
|
| Author: | Dart270 [ Mon May 21, 2018 2:48 am ] |
| Post subject: | Re: Pushrod length? |
Those numbers sound right to me. I usually get ones made in the 9.8" range for long valves, milled head/block, etc... Lou |
|
| Author: | slantzilla [ Mon May 21, 2018 10:42 am ] |
| Post subject: | Re: Pushrod length? |
Yep. 3/8" 9.800" long on the way.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|