I know diddly about EFI (and personally, care less
), but saw this over on Bangshift this morning, and thought of you EFI types here.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Jeep 6 Sniper? https://www.slantsix.org/forum/viewtopic.php?t=62728 |
Page 1 of 1 |
| Author: | Old6rodder [ Mon Aug 20, 2018 10:12 am ] |
| Post subject: | Jeep 6 Sniper? |
I know diddly about EFI (and personally, care less ), but saw this over on Bangshift this morning, and thought of you EFI types here.
|
|
| Author: | sandy in BC [ Mon Aug 20, 2018 12:38 pm ] |
| Post subject: | Re: Jeep 6 Sniper? |
Take off a BBD and bolt on up to 350 hp. A BBD flows 255cfm Two 100lb injectors would drown a BBD compatible manifold at an idle. |
|
| Author: | Greg Ondayko [ Mon Aug 20, 2018 1:11 pm ] |
| Post subject: | Re: Jeep 6 Sniper? |
You could set the pulse width at 0.00001 sec for idle quality...  Greg |
|
| Author: | GTS225 [ Mon Aug 20, 2018 4:02 pm ] |
| Post subject: | Re: Jeep 6 Sniper? |
It says "supports up to 350 horse with 100 lb/hr injectors". That doesn't mean you have to get the big injectors, and I suspect Holley will want some intended use info before they send you the package. Looks neat, but $1000 neat? I ain't so sure. Wonder how it would work with a blow-through turbo or supercharger? Roger |
|
| Author: | OGLeanDart270 [ Mon Aug 20, 2018 8:43 pm ] |
| Post subject: | Re: Jeep 6 Sniper? |
I watched a vid and read some of the fine print. It states it is for normally aspirated engines only (although it does have a 2 bar map). It is 100 bucks more than the 2300 version and the 2300 is nicer I think (universal air cleaner). They really did set this up as a jeep BBD replacement, not a generic BBD. If you look at the IAC motor on the throttle body it is just barely below where the air cleaner attatches, and sticks out quite a bit. The way jeep air cleaners bolt on it isn't in the way but I doubt a Super Six air cleaner would clear it. BBD carbs don't have anything in the way in that area. Pretty sure the 100 lb injectors are fine, I think they alter fuel pressure or something to get them to idle on smaller motors. I have seen mild V6's with the 4 barrel that run and idle just fine and those are good to 650hp. There are even air cooled VW's running the four barrels. CFM would be a bit higher than a BBD as there is no venturi. Brandon |
|
| Author: | coconuteater64 [ Tue Dec 11, 2018 5:52 am ] |
| Post subject: | Re: Jeep 6 Sniper? |
For that money I'd just switch to propane for a simpler installation. Looks nice though. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|