Attachment:
IMG_2677.jpg [ 54.26 KiB | Viewed 3217 times ]
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Rocker arm measurment https://www.slantsix.org/forum/viewtopic.php?t=64385 |
Page 1 of 1 |
| Author: | 225dart [ Tue Jan 07, 2020 3:52 pm ] |
| Post subject: | Rocker arm measurment |
Hi All, been many years since I've been here since I sold the Dart and parts. But I am hoping you can help me on another project I have. Could someone please take a rocker arm measurement for me. I need to know the distance between the center of the adjuster ball to the center of the valve tip pad, where the valve stem is. This would be for adjustable rockers obviously. Thank You Very Much in advance! |
|
| Author: | and739 [ Tue Jan 07, 2020 7:26 pm ] |
| Post subject: | Re: Rocker arm measurment |
Attachment: IMG_2677.jpg [ 54.26 KiB | Viewed 3217 times ] |
|
| Author: | 225dart [ Wed Jan 08, 2020 2:57 am ] |
| Post subject: | Re: Rocker arm measurment |
AWESOME!! This might actually work. Now i just need to find a complete set up with shaft. What I am working on is a 1920's aftermarket overhead valve cylinder head for a Ford Model T. Early century speed parts. The rockers aren't being reproduced, plus are fragile----and I don't have any. But being a long time Mopar guy, I know how well Ma did at building tough parts. If anyone has a complete setup or two so I have spares, please contact me. best way is email, crazydart400 AT yahoo DOT com. Thank You! |
|
| Author: | Doctor Dodge [ Fri Jan 17, 2020 10:42 am ] |
| Post subject: | Re: Rocker arm measurment |
email sent. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|