| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Starter bolting question https://www.slantsix.org/forum/viewtopic.php?t=64388 |
Page 1 of 1 |
| Author: | Pgbarrow [ Tue Jan 07, 2020 5:00 pm ] |
| Post subject: | Starter bolting question |
Hi, As I have been looking at my bellhousing and starter it appears that I need to get specific bolts, not just something from the hardware store, due to chamfer and fit issues. Is this the case? I Googled and came up with some from Summit Racing. Sincerely, Paul Barrow |
|
| Author: | DusterIdiot [ Tue Jan 07, 2020 5:07 pm ] |
| Post subject: | Re: Starter bolting question |
The starter fasteners aren't special and can be grade 8, and the lower one is typically a stud/washer/nut and the other a bolt to hold the starter... the stud can be gotten from an autoparts store that has the orange dorman hardware bins.... |
|
| Author: | Joshie225 [ Wed Jan 08, 2020 8:57 am ] |
| Post subject: | Re: Starter bolting question |
The starter nose fits into a pocket in the bell so that it's positioned accurately. The bolts just hold it down. |
|
| Author: | Pgbarrow [ Wed Jan 08, 2020 11:46 am ] |
| Post subject: | Re: Starter bolting question |
Thanks guys, I'll head to the store then. Paul |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|