| Slant Six Forum https://www.slantsix.org/forum/ |
|
| US Source for the Aussie Speed Head Gasket? https://www.slantsix.org/forum/viewtopic.php?t=65625 |
Page 1 of 1 |
| Author: | hansbuscher [ Tue Dec 08, 2020 5:05 pm ] |
| Post subject: | US Source for the Aussie Speed Head Gasket? |
Hello All. Is there a US Source for the Aussie Speed Head Gasket? The head was cut .100" and I'd like to lower the comp a bit. Thanks. -ahb |
|
| Author: | Dart270 [ Wed Dec 09, 2020 3:33 am ] |
| Post subject: | Re: US Source for the Aussie Speed Head Gasket? |
You can get them from Aussie and often the shipping is not bad. Or, someone on this site might have a spare they will sell? http://www.precisionintl.com/StockSearc ... =14&Page=3 Best, Lou |
|
| Author: | Greg Ondayko [ Wed Dec 09, 2020 4:13 am ] |
| Post subject: | Re: US Source for the Aussie Speed Head Gasket? |
Is there any reason you can't use a felpro head gasket? They don't have a small compressed thickness.. Unless you are trying to use the big bore of the head gasket to lower compression further? I usually buy 5 at a time when the ex¢hange rate i$ favorable for the u$ Dollar. Greg |
|
| Author: | Dart270 [ Wed Dec 09, 2020 5:21 am ] |
| Post subject: | Re: US Source for the Aussie Speed Head Gasket? |
Felpro is usually around 0.034" compressed, Endurotec (Aussie) is 0.047". Not much difference, but something. I think the Victor, Corteco, and most other composite gaskets are over 0.040". Lou |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|