| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Cylender Head - TIPS! https://www.slantsix.org/forum/viewtopic.php?t=6650 |
Page 1 of 1 |
| Author: | 87Slant_sickness [ Thu Aug 21, 2003 6:18 pm ] |
| Post subject: | Cylender Head - TIPS! |
Hey all! Just got home from the machine shop, my slant head is "almost done" and i have to port it and do the bowl work then take it back for them to finish the seats and do the final decking after i cc the head (any tips/tricks for this?). I was wondering where the "thin" spots on the slant head that i have to be careful around?? I have ford 300Valves installed and i want to make sure the ports can handle the valves. I started opening up the area inbehind the seats (quite alot of material that has to be taken off). Is there a waterjacked inbetween the intake/exhaust valves? Thanks Justin |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|