| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Has any one seen this? (idon'twanttogentintoabigthingaboutoil) https://www.slantsix.org/forum/viewtopic.php?t=66910 |
Page 1 of 1 |
| Author: | Dart270 [ Wed Nov 23, 2022 11:04 am ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Interesting. Can't hurt to have some extra insurance, but I think extra zinc is not needed except perhaps on cam break in, or with a high lift and fast rate-of-lift camshaft. Lou |
|
| Author: | Rick Covalt [ Wed Nov 23, 2022 4:47 pm ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Is it just a marketing gimmick? Do they tell us how much zinc it really has compared to the new and old versions? Just thinking out loud. But I too think more zinc is not going to hurt. |
|
| Author: | Valleyant [ Wed Nov 23, 2022 7:25 pm ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Fact from Castrols MSDS 1400 PPM of zinc for this weight of oil and this specific "Classic high zinc" type..... When I get time I will check how it compares to other weights etc.... |
|
| Author: | SlantSixDan [ Wed Nov 23, 2022 9:21 pm ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Facts help with questions like this one. Here is a really good start. |
|
| Author: | ric325v63 [ Thu Nov 24, 2022 9:17 am ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
That was an excellent and illuminating read on oils. Thank you. |
|
| Author: | Greg Ondayko [ Fri Nov 25, 2022 2:23 pm ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Thanks Dan. I will read up on the report and i am sure it will help me make a more informed decision when oil shopping. Greg |
|
| Author: | Not2slow [ Tue Dec 27, 2022 12:16 pm ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Quote: Facts help with questions like this one. Here is a really good start.
That is a VERY extensive article. I'm an engineer and it was a bit much for me, but good info. I'll print it off and hand it to the next person that asks "what oil do you run?" |
|
| Author: | Greg Ondayko [ Tue Dec 27, 2022 1:25 pm ] |
| Post subject: | Re: Has any one seen this? (idon'twanttogentintoabigthingaboutoil) |
Quote: Quote: Facts help with questions like this one. Here is a really good start.
That is a VERY extensive article. I'm an engineer and it was a bit much for me, but good info. I'll print it off and hand it to the next person that asks "what oil do you run?" Yes thank you. It is extensive.. I wi hafta re read it a few times as I am but on the slow side, but It helped to make a more informed decision. Greg |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|