Sorry, I have searched the garage and tool room high and low, but I can't find it. It sat right there in the top of my big rolling toolbox for at least 7 years! But nobody knows anything about its current whereabouts.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Intake heater https://www.slantsix.org/forum/viewtopic.php?t=67001 |
Page 1 of 1 |
| Author: | Docmcg [ Fri Jan 06, 2023 9:36 am ] |
| Post subject: | Intake heater |
I’m going to use an Offy manifold w/Dutra duals. I need to heat the intake, and have read about a hot water block to bolt under the manifold and connect to the cooling system. Anyone know where to get such an item? Thanks,Steve. |
|
| Author: | Greg Ondayko [ Fri Jan 06, 2023 11:48 am ] |
| Post subject: | Re: Intake heater |
Here is a bit of a write up I found about one. https://www.forabodiesonly.com/mopar/th ... es.457828/ Good luck! Greg |
|
| Author: | wjajr [ Fri Jan 06, 2023 12:40 pm ] |
| Post subject: | Re: Intake heater |
I made one of these water heated hot spots in 2008 to solve a carburetor icing problem with a Clifford shorty intake and headers. It has worked great ever since. I spliced into the heater coolant circuit in series, circulating 195* coolant. I have driven the car in sub zero to high 90's weather with no problem. I had written this project up in 2008, but can't locate it using search. |
|
| Author: | SlantSixDan [ Sat Jan 07, 2023 11:24 am ] |
| Post subject: | Re: Intake heater |
Last item on this page. Frank Raso is a longtime Slant-6er. |
|
| Author: | kesteb [ Thu Jan 12, 2023 2:56 pm ] |
| Post subject: | Re: Intake heater |
If the junk yards in your neck of the woods still have old Ford trucks, Ford made a nice water heated spacer for between the carburetor and manifold. There are both 2v and 4v versions. I would look for a F150 with a 390 FE series engine. |
|
| Author: | coconuteater64 [ Thu Jan 12, 2023 3:03 pm ] |
| Post subject: | Re: Intake heater |
Quote: If the junk yards in your neck of the woods still have old Ford trucks, Ford made a nice water heated spacer for between the carburetor and manifold. There are both 2v and 4v versions. I would look for a F150 with a 390 FE series engine.
I have such a creature if you want it. I got it to put between my Holley 350 cfm and modified Super Six intake but never used it.
|
|
| Author: | coconuteater64 [ Mon Jan 16, 2023 9:07 am ] |
| Post subject: | Re: Intake heater |
Sorry, I have searched the garage and tool room high and low, but I can't find it. It sat right there in the top of my big rolling toolbox for at least 7 years! But nobody knows anything about its current whereabouts.
|
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|