Slant Six Forum
https://www.slantsix.org/forum/

spark plug tubes
https://www.slantsix.org/forum/viewtopic.php?t=68276		 Page 1 of 1
Author:  Badvert65 [ Sat Jul 05, 2025 9:37 am ]
Post subject:  spark plug tubes
Anyone have or could make technical drawings of the spark plug tubes? I am looking to have them manufactured.
Author:  SlantSixDan [ Sat Jul 05, 2025 1:04 pm ]
Post subject:  Re: spark plug tubes
Looks like the Aussies done beatchya to it .
Author:  Reed [ Sat Jul 05, 2025 2:52 pm ]
Post subject:  Re: spark plug tubes
Quote:
Looks like the Aussies done beatchya to it .
Yup, but if you can beat the $97 cost with shipping price point, you might sell some sets.
Author:  Badvert65 [ Sun Jul 06, 2025 5:13 am ]
Post subject:  Re: spark plug tubes
I knew the Aussies made a really nice set of billet ones, I am looking to have them made like the originals, stamped from aluminum sheet.
Author:  Charrlie_S [ Sun Jul 06, 2025 5:36 am ]
Post subject:  Re: spark plug tubes
Quote:
I knew the Aussies made a really nice set of billet ones, I am looking to have them made like the originals, stamped from aluminum sheet.
I was aware of the Aussie tubes. I had reservations about the thickness of the meterial against the head at the spark plug seat. Was concerenrd about the positioning of the end of the plug in the chamber, and the heat transfer properties affecting the heat range of the plugs.
Author:  SlantSixDan [ Wed Jul 09, 2025 3:02 pm ]
Post subject:  Re: spark plug tubes
Quote:
I had reservations about the thickness of the meterial against the head at the spark plug seat. Was concerenrd about the positioning of the end of the plug in the chamber, and the heat transfer properties affecting the heat range of the plugs.
That's a really good point. If they (or somebody else's machined plug tubes) are too thick there at that end, I wonder if they could be machined thinner.
Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/