P4529343 Purple Shaft .528 Lift, 284 Duration
What do you think?
| Attachments: |
|
P4529343 (1) s.JPG [ 33.75 KiB | Viewed 1355 times ] |
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Run it or Chuck It? https://www.slantsix.org/forum/viewtopic.php?t=68528 |
Page 1 of 1 |
| Author: | hyper_pak [ Fri Feb 06, 2026 11:56 am ] | ||
| Post subject: | Run it or Chuck It? | ||
P4529343 Purple Shaft .528 Lift, 284 Duration What do you think?
|
|||
| Author: | Greg Ondayko [ Fri Feb 06, 2026 12:31 pm ] |
| Post subject: | Re: Run it or Chuck It? |
Its on the base circle? I bet it will be fine @ 0.028" or so If you want to / decide to throw it away, I have a lead on someone looking for one of those 0.528" cams. Greg |
|
| Author: | Dart270 [ Sat Feb 07, 2026 4:01 am ] |
| Post subject: | Re: Run it or Chuck It? |
Agree with Greg. If on base circle, you are good to go most likely. That should be a great cam for 10-10.5:1 or so motor. Lou |
|
| Author: | Rick Covalt [ Sat Feb 07, 2026 9:11 am ] |
| Post subject: | Re: Run it or Chuck It? |
Or a great lobe wiper. Not because of your corrosion. There was just a bad bunch of the .528 cams that wiped lobes. But you probably already knew that. I'd take some crocus cloth or similar to it an run it. |
|
| Author: | hyper_pak [ Sat Feb 07, 2026 9:25 am ] |
| Post subject: | Re: Run it or Chuck It? |
It has been run, I do not have any history on it. |
|
| Author: | slantzilla [ Mon Feb 09, 2026 5:22 pm ] |
| Post subject: | Re: Run it or Chuck It? |
There was a batch of .528s that killed oil pump gears too. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|