| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Super six manifold https://www.slantsix.org/forum/viewtopic.php?t=68598 |
Page 1 of 1 |
| Author: | RumDungeon [ Fri Apr 10, 2026 10:17 am ] |
| Post subject: | Super six manifold |
Just need the intake for a friend in need. In Northern California but willing to pay shipping. |
|
| Author: | SlantSixDan [ Fri Apr 10, 2026 4:07 pm ] |
| Post subject: | Re: Super six manifold |
Read down to the bottom of this ad over on FABO |
|
| Author: | RumDungeon [ Sat Apr 11, 2026 4:53 am ] |
| Post subject: | Re: Super six manifold |
Quote:
Read down to the bottom of this ad over on FABO
Im just seeing 318 stuff, nothing for a slant.
|
|
| Author: | SlantSixDan [ Sat Apr 11, 2026 5:18 pm ] |
| Post subject: | Re: Super six manifold |
Oh, sorry, right, it's a V8 intake. |
|
| Author: | volaredon [ Sun Apr 12, 2026 6:14 am ] |
| Post subject: | Re: Super six manifold |
I know where there's one at but shipping would likely kill a deal. Especially these days |
|
| Author: | hyper_pak [ Sun Apr 12, 2026 10:17 am ] |
| Post subject: | Re: Super six manifold |
They fit in a USPS Flat Rate Game Box. If you can find one. I picked up a pack of them when they Disco-ed them. |
|
| Author: | RumDungeon [ Mon Apr 13, 2026 8:53 pm ] |
| Post subject: | Re: Super six manifold |
I don’t mind paying shipping, it’s finding one that’s the issue. The were never specced for CA so they aren’t common in yards here. |
|
| Author: | Rob Simmons [ Tue Apr 14, 2026 6:04 am ] |
| Post subject: | Re: Super six manifold |
I probably have a couple. I will look next time I’m over at the shop. |
|
| Author: | RumDungeon [ Tue Apr 14, 2026 11:56 am ] |
| Post subject: | Re: Super six manifold |
Quote:
I probably have a couple. I will look next time I’m over at the shop.
Thanks Rob!
|
|
| Author: | RumDungeon [ Sun Apr 19, 2026 6:39 am ] |
| Post subject: | Re: Super six manifold |
Still looking |
|
| Author: | SlantSixDan [ Sun Apr 19, 2026 12:03 pm ] |
| Post subject: | Re: Super six manifold |
Well, you might wind up making your own. See the parallel 2bbl setup article. Photo documentation of a very well done such conversion is here, and there's a nice pictorial on modifying a 1bbl intake here. You can also modify a 1bbl intake to have a factory-type perpendicular 2bbl carb mount; read this (whole) thread for pics and descriptions of how to do so. Either way, pay careful attention to the carburetor mount pad angle. It's not supposed to be just flat with the top surface of the intake manifold; it needs to tilt the carburetor forward a bit, so the carb will be upright with the intake installed—the engine has a slight rearward tilt. 3° sticks out in mind, but that might not be correct; measure a stock manifold to find out for sure. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|