| Slant Six Forum https://www.slantsix.org/forum/ |
|
| New cam arrived...valve lash? https://www.slantsix.org/forum/viewtopic.php?t=7927 |
Page 1 of 1 |
| Author: | 66coronet [ Tue Dec 23, 2003 7:29 pm ] |
| Post subject: | New cam arrived...valve lash? |
Well, my purpleshaft came in today. Here are the specs from the box: .528", 284 duration, 76 overlap, 102 centerline. Anyone have any idea what valve lash is needed to run this cam? |
|
| Author: | DusterIdiot [ Tue Dec 23, 2003 10:10 pm ] |
| Post subject: | 343? |
MP guide says MP p/n P4529343 Mech lifters adv dur=284/284 76 overlap .528 lift Valve lash= .028/.032 Cam c-line=104 installed c-line=102 good luck, make sure to lap the oil pump gear in lots of posts about MP cams chewing up them gears... -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|