| Slant Six Forum https://www.slantsix.org/forum/ |
|
| How to keep ignition switch from turning on 63 Dart? https://www.slantsix.org/forum/viewtopic.php?t=9003 |
Page 1 of 1 |
| Author: | Walter Lee Jackson [ Sun Apr 11, 2004 11:00 am ] |
| Post subject: | How to keep ignition switch from turning on 63 Dart? |
I've got a 1963 Dart. The original ignition swith had a small tab on the end (that fit through a slot on the dashboard) that kept the switch from turning even if the chrome trim ring/nut came loose. Today all you can find is the switch without the tab. Result: if the chrome trim ring/nut becomes the slightest bit loose, the whole switch turns. Does anyone have a solution to this problem? TIA --Walt Jackson |
|
| Author: | 63gtcv [ Sun Apr 11, 2004 4:54 pm ] |
| Post subject: | spiner |
Mr. Jackson, you might be able to find a good used switch with key. I am assuming your's is not origional. If this is the case then you already have a different ign. key anyway. |
|
| Author: | steponmebbbboom [ Sun Apr 11, 2004 8:15 pm ] |
| Post subject: | |
If you had no other choice, you could drill a 1/16'' hole where the tab used to be and tap a small roll pin in there. Ive done it before and if you had a steady hand you could as well. But replacing the switch is the more favorable option IMO. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|