| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Question about 360/340 valve springs https://www.slantsix.org/forum/viewtopic.php?t=9259 |
Page 1 of 1 |
| Author: | Matadem [ Thu May 06, 2004 8:44 pm ] |
| Post subject: | Question about 360/340 valve springs |
because I was looking for some 340 valve springs on ebay and came across this are they the same ?  Brand new set of 16 valve springs for 318 340 360 Chrysler 2-bbl and any SB Mopar with stock or RV torque cam. http://cgi.ebay.com/ebaymotors/ws/eBayI ... ename=WDVW |
|
| Author: | Eric W [ Thu May 06, 2004 10:37 pm ] |
| Post subject: | |
I believe the 340 springs are stiffer because the 340 was designed to be a high revving engine. Six thousand + rpm is nothing for a stock 340. |
|
| Author: | slantzilla [ Sat May 08, 2004 6:34 am ] |
| Post subject: | |
The stock 340 springs are good for a cam lift of around .525". The springs you have listed there probably wouldn't do much more thn a stock Slant spring. 
|
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|