I've looked at Summit, Vato Zone, Schmuck's, Jegs and Napa and had no luck finding the correct studs (or nuts) for my Duster's cylinder head. Anyone know of a source that still sells the right parts? I've looked 'em up by P/N on each site, and gotten nothing.

_________________
'74 Duster w/ HEI ignition, beat to snot suspension, A904, 8.25" 3.55 SG rear, still being tuned up and gets 17 MPG

Know how they always build a better idiot? That's me

Go into the store; they may not be listed on the web site. NAPA would be my first choice. Failing that, try a nut and bolt supply company. They are really nothing special so just take a sample with you. Just remember that the coarse thread end goes into the head and the nuts are need for the fine thread end. I believe they are 5/16 but I don't recall the length.

_________________
David Kight
'62 Valiant Signet, White
'98 Dodge Dakota
'06 Jeep Liberty

Growing older is unavoidable but growing up is strictly optional.

Rockauto will have 'em, but so will a fastener supply store. They're double-ended 5/16" fine-thread/coarse-thread, 2" overall length if I'm not mistaken.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

I got mine at 'Vato Zone' but had to go behind the counter and they had one less than I needed, why is that always the case? Vato Zone, I think they just got a new nickname. hee hee.

_________________
/6 '67 Barracuda convertible, electronic ignition, 4-OD, street cam, SBP KH discs, 3.55 SG 7.25" 1" t-bars. Bilstein.
340 '67 fastback, Doug Nash 5-speed.
1988 Toyota pickup work truck

any ace hardware stores close by-- they should have them!!