Piston Question

Unanswered topics | Active topics

Home » Board index » Tech Q & A » Engine

All times are UTC-07:00

Post new topic Reply to topic

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Tom Gilsdorf

Post subject: Piston Question

PostPosted: Fri Sep 13, 2002 8:22 pm

We were talking a few weeks ago about the supply of KB268's drying up. I was nosing around the KB website and ran across this piston for the 2.5L engine. Wrist pin dia and, bore and compression height look good. Any chance this may be a good substitute for the Long Rod's?

L4 153
2.5 L
3.4449(IN)
87.5(MM)

CHRYSLER
ENGINE 1986-88

9.0 2.64" dia. head recess .161" deep. Non-turbo, non-EFI.

APPROXIMATE HEAD VOLUME=13.5cc

Comp. Ht. 1.573
Pin Dia..9009 Offset 1292
Std.
.5mm
.75mm
1.0mm 2-1.5mm
1-4.0mm
4397636
4323023

Gilly

tlg225ccr@aol.com

Top

Reply with quote

Doctor Dodge (Doug Dutra)

Post subject: Re: Piston Question

PostPosted: Sun Sep 15, 2002 9:41 am

Good detective work, I will give my friends at KB a call and get them to send me a sample so we can give it a close look-over.
DD

Quote:

:
: We were talking a few weeks ago about the
: supply of KB268's drying up. I was nosing
: around the KB website and ran across this
: piston for the 2.5L engine. Wrist pin dia
: and, bore and compression height look good.
: Any chance this may be a good substitute for
: the Long Rod's?
:
: L4 153
: 2.5 L
: 3.4449(IN)
: 87.5(MM)
:
: CHRYSLER
: ENGINE 1986-88
:
: 9.0 2.64" dia. head recess .161"
: deep. Non-turbo, non-EFI.
:
: APPROXIMATE HEAD VOLUME=13.5cc
:
: Comp. Ht. 1.573
: Pin Dia..9009 Offset 1292
: Std.
: .5mm
: .75mm
: 1.0mm 2-1.5mm
: 1-4.0mm
: 4397636
: 4323023
:
: Gilly