I have a 8" Ford rear that I am trying to remove the center section to take to Lou at the banquet next week. One axle came right out. Second axle did not. Spray with PB Blaster, Pound on axle. Spray with more Blaster, heat housing with torch! Pound on axle! Spray more blaster, go get Axle puller slide hammer, heat housing, pound with slide hammer. Hand hurts, go home So any ideas on getting this out? I'm about to cut the housing in two with a torch!!

Thanks, Rick

PS axles are going in the junk so no worries about them.

let the axle end soak in a bucket of kerosene for a week

_________________
V8?? We don't need no stink'n V8!!