Hello All.
Is there a US Source for the Aussie Speed Head Gasket? The head was cut .100" and I'd like to lower the comp a bit.


Thanks.
-ahb

You can get them from Aussie and often the shipping is not bad. Or, someone on this site might have a spare they will sell?

http://www.precisionintl.com/StockSearc ... =14&Page=3

Best,
Lou

_________________
Home of Slant6-powered fun machines since 1988

Is there any reason you can't use a felpro head gasket?


They don't have a small compressed thickness..

Unless you are trying to use the big bore of the head gasket to lower compression further?

I usually buy 5 at a time when the ex¢hange rate i$ favorable for the u$ Dollar.


Greg

_________________
http://www.youtube.com/hyperpack

Felpro is usually around 0.034" compressed, Endurotec (Aussie) is 0.047". Not much difference, but something. I think the Victor, Corteco, and most other composite gaskets are over 0.040".

Lou

_________________
Home of Slant6-powered fun machines since 1988