I need to get a ratchet strap, thanks Reed.
It would probably also help if I had more space and a better floor jack, but oh well.
I did get the power steering pump and bracket reinstalled on the new slant six, I even installed the p.s. belt.
But I gotta get that tranny in...

_________________
"Ja, Ich fahre ein altes auto."
'78 Volare 225
'67 Charger 318

How far away are you? 1/8"? 1/4"?

_________________
2 Mopars come with Spark plug tubes. One is a world class, racing machine. The other is a 426 CI. boat anchor!

12.70 @ 104.6

It looks like Less than 1/4".

_________________
"Ja, Ich fahre ein altes auto."
'78 Volare 225
'67 Charger 318

Might be able to get a bolt started on the other side and draw it in that much (or little)

Don, that's what I was thinking about.
Actually, I have the bolts started on that side.

_________________
"Ja, Ich fahre ein altes auto."
'78 Volare 225
'67 Charger 318

Wes just pay attention as you tighten it down. if it gets any kind of hard to turn the wrench/ratchet before the gap between the bell housing and block is gone... something is wrong so stop.

yes i have seen this and even did it once... broke the bellhousing.
in my case it was a replacement motor that still had the pilot bushing in the crank. the poor 904 automatic did not survive. yes this is the extreme end of something is wrong.


not trying to scare you off, just making the heads up. ratchet turns steady easy with one hand... good to go. ratchet gets hard enough to want to use 2 hands stop and back up. look to find what the error is.

Thanks for the response Eric, and everyone else.

So, it did get difficult to turn the wrench, and I stopped. Then I backed off the bolts a couple of turns.
I think I'm going to hold off on the trans for now, and do everything else.
I installed the alternator bracket, power steering pump, the fan, and the two belts.

On the alternator, can someone direct me to a clear pic of how the alt sits in that bracket?

Thanks, thanks, thanks!

_________________
"Ja, Ich fahre ein altes auto."
'78 Volare 225
'67 Charger 318

I was gonna ask if the replacement engine came out of a stick vehicle.

The replacement came out of a automatic equipped Volare.
Relevant question though.

_________________
"Ja, Ich fahre ein altes auto."
'78 Volare 225
'67 Charger 318

ok you have confirmed no pilot bushing, so what is left for issues is
1) something stuck between bell and motor... wiring of hoses etc. you should be able to see this from top or bottom.
2) extra dowels 2 in new motor and one in transmission. check the motor that came out for 2 dowels

3 misalignment, dowel not lining up with the hole in the bell housing. loosen all bolts but do not remove any. wiggle and jiggle transmission till it drops together. make sure convertor is all the way back in transmission and motor mounts are loose so every one can move while you wiggle.
if you can get a sight line on that side's dowel you might be able to see which way what has to move, ie tranny on that side needs to go higher to line up.

Loosen up the side that\s pulled together and make sure all the bolts are started but not tight. Then work side to side pulling it in.

I have 6" long bolts for the 2 bottom holes that I use to guide the motor/trans together.

Patience is the key.

_________________
Official Cookie and Mater Tormentor.