Slant Six Forum
https://www.slantsix.org/forum/

Super six swap question
https://www.slantsix.org/forum/viewtopic.php?t=10026
Page 1 of 1

Author:  golembieski [ Thu Aug 05, 2004 1:01 pm ]
Post subject:  Super six swap question

Ok i found a whole super six setup and i was planning a swap i was wondering if the exhaust will match up or will i have to run open to the shop, I know there is a 1/4 size differance but i realy didn't have a chance yet to check the angles.

Author:  70valiant [ Thu Aug 05, 2004 1:24 pm ]
Post subject: 

the opening on both manifolds is the same size 1 7/8" but there is a slight angle difference between the 2. to get it to seal I just took the bolt out that holds the exhaust pipe bracket to the trans. then snugged both exhaust manifold to pipe nuts

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/