Hey
My last repair to my clutch lasted about 5 months,again the clutch fork fell off the throw out bearing,which isn't the worst. While limping home tried to go from 2d to neutral and jammed it into 1st where it is now stuck.
Advice/suggestions appreciated.
I am 'bout ready to go to an automatic,but I got this truck just because it had 225/ and o/d tranny!
I have worked repeatedly on this fork problem, could the problem be the (made in china) clutch assymbly?
robert

Did you use the %^%$^ chinese throwout bearing that came with it?

If so that may be some of it...

-D.Idiot

I didn't, no. The Chinee stuff was extant when I got the truck, I have been trying to deal with it but it seems it's cost me my trans.
Was hoping to get an Idea as to how to deal, I do have an extra auto trans but would like to keep the A833
robert