Simple enough, I can handle that.
Thanks very much
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| How to set initial distributor adjustment. https://www.slantsix.org/forum/viewtopic.php?t=47624 |
Page 1 of 1 |
| Author: | Hewy [ Wed Jan 18, 2012 3:29 pm ] |
| Post subject: | How to set initial distributor adjustment. |
It is the mounting plate I'm questioning. One end bolts to distributor body, the other end bolts to engine. Is there a starting point for setting the distributor bolt ? As in the middle of the slot arc ? Where do I start ? Which one is used for final timing light adjustment ? Help. |
|
| Author: | hantayo13 [ Wed Jan 18, 2012 5:22 pm ] |
| Post subject: | |
tighten one under dist in the middle....bring engine to TDC on #1 ...install dist so rotor end up pointing at #1 on cap....use base bolt to adjust timing ....if a bit more is needed use bolt under dist .... if not enough remove and move a tooth....if done right both bolts should be near center of slot |
|
| Author: | sandy in BC [ Wed Jan 18, 2012 5:48 pm ] |
| Post subject: | |
<CORRECT>! |
|
| Author: | Hewy [ Wed Jan 18, 2012 6:25 pm ] |
| Post subject: | |
Simple enough, I can handle that. Thanks very much
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|