| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 225 manifold https://www.slantsix.org/forum/viewtopic.php?t=50820 |
Page 1 of 1 |
| Author: | slant6 [ Mon Jan 14, 2013 5:42 am ] |
| Post subject: | 225 manifold |
My manifold has 2 hard line fittings on each side approx center. One side it broke off inside and it floats in there but can't get it out. Is these 2 fittings attach to my single barrel carb to suck air? Also can I just tap them and run partial hard line then hose? Thanks Dana |
|
| Author: | mpgmike [ Mon Jan 14, 2013 9:49 am ] |
| Post subject: | |
Even a bad picture can be better than a good description. Can you oblige? Mike |
|
| Author: | Reed [ Mon Jan 14, 2013 10:11 am ] |
| Post subject: | |
Intake or exhaust manifold? If exhaust manifold, you likely have one of the somewhat rare (at least in the US) anti-icing air heating systems that ran a tube through the exhaust manifold to pre-heat the air going into the carb. See HERE. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|