| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Building a Motor for the first time. https://www.slantsix.org/forum/viewtopic.php?t=5701 |
Page 1 of 1 |
| Author: | Hoemy [ Thu May 08, 2003 10:11 am ] |
| Post subject: | Building a Motor for the first time. |
Hi Everyon, I picked up a slant six from a friend of mine and am putting it in a 67 Cuda. The truck that my friend had this motor in before he sold it to me ran 13.2. I don't know much about the motor other than it is the 225 and I believe the compression is 12.5 - 1. I am now getting ready to put the motor in my car but I need a carb. I was wondering if anyone had any suggestions on which carb I should get and how big ( I already have a 4 barrel intake). Also, I am changing this motor over to electronic ignition, any suggestions on what I should get? Thanks for all you help. Hoemy |
|
| Author: | killin5 [ Thu May 08, 2003 12:05 pm ] |
| Post subject: | |
If the engine came from a truck, you may need a different oil pan. |
|
| Author: | Reed [ Thu May 08, 2003 1:34 pm ] |
| Post subject: | |
You will need a different oil pan and oil pickup tube. You also will need to get a slant six electronic ignition distributor. I would start with a Edelbrock 400 CFM carb or a Holley 390 CFM carb. Reed |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|