| Slant Six Forum https://www.slantsix.org/forum/ |
|
| tail bushing and yoke clearance https://www.slantsix.org/forum/viewtopic.php?t=59888 |
Page 1 of 1 |
| Author: | '67 Dart 270 [ Sun Jul 10, 2016 3:02 pm ] |
| Post subject: | tail bushing and yoke clearance |
Anyone know what the gap is supposed to be between the tail bushing and the slip yoke in an A 904? I have a new bushing and it seems like the gap is pretty big, wondering if it's the wrong bushing. brian |
|
| Author: | ProCycle [ Sun Jul 10, 2016 3:27 pm ] |
| Post subject: | |
I can't say precisely but for any bushing to carry a load properly the fit has to be pretty close. I would expect a couple or a few thousandth clearance. More than that wouldn't be very good. |
|
| Author: | '67 Dart 270 [ Sun Jul 10, 2016 9:30 pm ] |
| Post subject: | thanks... |
That's what I would expect, it seems more than that. My yoke doesn't seem worn in any discernible way, I'll measure the I.D. of the bushing that's in there now and compare. Brian |
|
| Author: | Joshie225 [ Sun Jul 10, 2016 9:44 pm ] |
| Post subject: | |
Have you driven the bushing into the tail housing or is it loose? |
|
| Author: | '67 Dart 270 [ Mon Jul 11, 2016 4:25 pm ] |
| Post subject: | New |
I have not installed. I assume you are suggesting that it compresses some when installed. Brian |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|