| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Torque Convertor Numbers https://www.slantsix.org/forum/viewtopic.php?t=7302 |
Page 1 of 1 |
| Author: | RG [ Tue Oct 21, 2003 8:13 am ] |
| Post subject: | Torque Convertor Numbers |
I recently purchased a rebuilt pushbutton 904 from a defunct dealership that was sitting for years. The tranny has a long tailshaft and the numbers on the case indicate it is somewhere around a 1964 vintage. My question is did they use different torque convertors on the 904? My '64 parts book only shows one number, but the input spline count is different than the 904 that is currently in my '64 Dart. |
|
| Author: | Charrlie_S [ Tue Oct 21, 2003 6:06 pm ] |
| Post subject: | |
How many splines? The 64 trans should have 18 splines. In 1968 the shaft diameter was increased, and the spline count went to 27. At the same time the diameter of the hole, and the flex plate register in the end of the crank changed. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|