Earlier in this post I asked if the manifold was for a "super six" 2bbl or 1bbl - to clarify - is the manifold to exhaust pipe connection larger in diameter for the 2bbl ? Or is the diameter the same for both the 1bbl and 2bbl manifolds ?

thanks jeff

Same. There is no difference between the exhaust manifolds used with 1bbl and with 2bbl setups.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

And if you are wondering about this manifold, the exhaust pipe ID is 2" at the flange. I just measured it today.

_________________
"Mad Scientist" Matt Cramer
'66 Dart - turbocharged 225
My blog - Mad Scientist Matt's Lair

Thanks

I also purchased a "A-1" exhaust manifold. The casting was very poor and actually had sand holes in the casting below the heat riser. I repaired it with J B Weld prior to installation and it's been fine so far. It also had the "China" name cast in to it. If I had it to do again, I would buy one from a junk yard !!!