I found another BBD. I think it's older type. It has flat accelerator pump shaft.
Here is picture of it
http://www.slantsix.org/articles/choke- ... rvice1.jpg

I would like to have adjusting instruction for this carburetor if anybody knows how to adjust it and if it's possible to adjust. Also there was no accelator pump arm installed, I do not know why , but I made one by myself, problem is that I do not know what is correct length for it.

_________________
Sorry, my english is not very good

No answer???


Is my english really so bad.

_________________
Sorry, my english is not very good

I have one of those carbs sitting on my bench at the moment waiting for a rebuild, i'm not sure if they are any "bigger" but they sure are different!

anyways i dont know of the adjustments as of yet, i'll know tommorow if you can wait till then (i'll have my rebuild kit tommorow at 9am)

and know your english is just fine

Justin

would help if i logged in first



Justin

Justin,

You don't need to log out. Just close the browser when you are finished.

_________________
Chuck Rivers, Webmaster

Thanks Justin

Is it possible to copy me that manual, which comes with rebuild kit ?

I also still want to know, what is correct length for the 'Throttle connector rod' ( part number 4 in that picture-- http://www.slantsix.org/articles/choke- ... rvice1.jpg). When I get that carb it was missing that part, and there was other damages also which i have already repaired.

It might be that i'll never need that carb, but I would like to make it work and try it .
The other newer Carter BBD I have, is now rebushed and I also had to make new throttle axle, because the original was too much worn. I'm now adjusting it and I will let you all know what is the result.

_________________
Sorry, my english is not very good

I still need that rod length.

Joug

The rod is 90mm long between to locating bends.

Hope this helps.

Thank you very much

_________________
Sorry, my english is not very good

I may have a rebuild sheet. Let me know if you still need it.

_________________
Chuck Rivers, Webmaster

Thanks Chuck. I still need it.

_________________
Sorry, my english is not very good

Joug,

I have the instructions for you in JPG format. The problem is that these files are large, about 1.3mb total. You also can't print them out from a browser because the page size is large. If I reduce them there will be a significant loss in quality. You will need some kind of photo editor to print them. What do you want me to do? I can send you a zipped up file of the 4 pages but it will take a long time to download if you are using a modem connection

_________________
Chuck Rivers, Webmaster

Chuck

I have no problems with jpg's and there is enough space in my email. So if you can send them to me , I will be very happy.

Joug

_________________
Sorry, my english is not very good

OK, just let me know if there is a problem.

_________________
Chuck Rivers, Webmaster

Thank you Chuck.

No problems and very nice to have so good quality scanned instructions.

Joug

_________________
Sorry, my english is not very good