Hi guys, more questions for 904 disassembly.
I am trying to remove the tail shaft but for my 63 which uses the trunnion there is a flange which needs to be removed. I have a 1 1/16" socket which is too small for the nut. Can anyone confirm the size of the nut, 1 1/8" or 1 3/16"?
Also the service manual refers to a funky tool, C-3381, to hold the flange so it does not rotate. Looks like I can use some angle iron with a couple of holes drilled in it to hold the flange to prevent rotation. Anyone had to confront this?
Thanks folks.

_________________
Psychics will soon lead dogs to your body!

1963 Dodge Dart 270 convertible

Forgot to include the picture.
http://www.myfigtree.com/flangnut1.jpg

_________________
Psychics will soon lead dogs to your body!

1963 Dodge Dart 270 convertible

Yeah, I just did as you said, a piece of scrap metal with two holes, worked fine.

Thanks Lancer, do you remember the socket size? 1 1/8"11?
John

_________________
Psychics will soon lead dogs to your body!

1963 Dodge Dart 270 convertible

I measured the nut on 3 speed manual it is 1 1/8"

Richard

_________________
Part of Tyrde-Browne Racing

Thanks a bunch fopar!

_________________
Psychics will soon lead dogs to your body!

1963 Dodge Dart 270 convertible