I want to install a oil pressure sending unit for my oil pressure gauge along with my oil pressure switch. Does someone make an adapter to hook up both on my oil pump?

Thanks,

bwhitejr

Yes, Weatherhead makes one... It's called a brass tee fitting, and can be had in any hardware store.

D/W

_________________

If it ain't broke, fix it!

There is also a combination switch/sender unit that'll work. Think it's even a Mopar part. Ebooger wrote about it in one of his "Mopar Action" issues; I'll see if I can prise the P/N out of him.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

i think the one out of a jeep wrangler will work as they have a light and a gauge. the one i did was on a 90. can't remember how the wiring works though...

zedpapa

_________________
1970 dodge dart w/225 /6 bored .040" over, holley 390cfm w/vac. sec., compcams 252s, clifford shorty headers w/2.5" exhaust w/flowmaster, f-body 11" front discs, aluminum A-833OD, 8 1/4 w/3.21 SG
soon to have 5 gears!!!

You can make a tee fitting with all related adapters / Pats from any hardware store. Use teflon tape and tighten it down snug!

GReg

_________________
http://www.youtube.com/hyperpack

Ebooger says "I never actually confirmed that the dual-sender works with the old gauges, but P/N 5233396 is the best shot."

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.